Standard carbon steel 1-1/16 inch diameter, 80 gram case hardened pinball
Dot matrix display (DMD) for pinball machines
Standard carbon steel 1-1/16" diameter, 80 gram pinball
Leg bolt 3/8-16 thread with 5/8 inch acorn head and 2-1/2 inch length.
Standard pinball playfield tempered glass.
Pop bumper (jet bumper, thumper bumper) ring and rod assembly.
Flipper rebuild kits for late model Sega & post 2000 Stern pinball machines includes...
Backbox latch hex key wrench tool for Data East / Sega / Stern
Ten-bulb box of #89 high quality miniature incandescent lamps.
Common solenoid coil used on many manufacturers pinball machines.
Black plastic cashbox used in most solid state pinball machines
Ten-bulb box of #906 High quality miniature incandescent lamp. May be replaced with 05-906W LED or 04-0912 bulbs.
HD Anti-reflection Glass playfield 21 x 43 x 3/16 inch
CPU/Sound Board for late model Stern pinball machines with White Star syst...
USE AE-23-800-01 as an equivalent substitute
Flipper coil with diode for solid state flipper systems.
Leg - 30-1/2 inch black textured
Pin-Buddy™ combo kit
I/O Power Driver Board Revision "G" used on Sega/Stern White Star System.
Shorter barrel spring for ball shooter assembly on all Data East, Sega, an...
Spring washer 1/2 inch inner diameter and 3/4 inch outer diameter commonly used on...
Pin-Buddy™ Game Saver Cantraption&tm 45°
Data East / Sega/ Stern flipper coil
PINSKIN™ Pinball Cover - Exhibit Stern SPI
Wide top rollover plastic drop target for many Stern games. Target head is...
Complete shooter assembly includes housing, shooter rod, inner green spring.
Glass corner protectors - Set of 2
Pinball Event Tune-Up Kit
Fluorescent lamp starter for F-14-15-20 watt lamps. FS-22 replaces FS-2
Knocker/ kickback plunger assembly used in ball launch assembly 500-5477-01
Coil - solenoid flipper Stern no diode
Bridge rectifier CM3501 DB3501
Hole guard - switch slot 1-1/4 inch
Sega/DE/Stern Lift Trim is 26-1/16 inch long with 3/16 inch channel.
Data East/Sega/Stern 26-1200 solenoid coil with diode
Transistor N channel 100v 20a Mosfet TO-220 110-0088-00
Red twist-lock plastic min dome for flash lamps. 550-5030-02
Display power supply board Whitestar/SAM
Plunger and link assembly for Data East/ Sega / Stern flipper assemblies.
Ball shooter rod for Capcom / Data East / Sega / Stern pinball machines.
MOSFET transistor driver N channel 100V - 0.07 ohm - 22A
Guard - shooter lane Stern
Yellow 3 inch molded flipper and shaft assembly with 2-3/16 inch (55mm) shaft...
Integrated Circuit 2K by 8 CMOS static 24 pin RAM chip. Replaces 5340-09878-00
Left plunger, link and crank (pawl) assembly used on all new Stern1 games
New single flipper button cabinet switch assembly with the new low-arcing.
Data East / Sega /Stern Display Controller board for White Star system games. Replaces 520-5044-XX
Right plunger, link and crank (pawl) assembly used on all new Stern1 games...
IC - 28 pin DIP NVRAM FM1608-120
Pin-Buddy™ Game Saver Cantraption™ 180°
Dual-opto receiver board assembly with grommets. Replaces 520-5174-00 without grommets
Late model Sega & post 2000 Stern pinball machines includes...
Stern power transformer.
Dual opto transmitter board assembly with grommets.
Clear plastic playfield post or standoff is 1-1/16 inch. Replaced by 03-7542-13
Data East / Sega / Stern trip coil
Black mylar cabinet pivot bolt cover disc for Sega and Stern pinball machi...
Standard pinball playfield Invisiglass.
Sub miniature snap action switch with 3 terminals and custom wireform
Post screw hex#6 / 6-32 machine screw 2 inch long, steel zinc.