Wiring harness Gottlieb System 80 - 5 inch


Wiring harness with card edge connectors for Gottlieb System 80 machines measures approximately 5 inches to completely replace the often corroded A1-J4 to A3-J1 wiring harness.

The pre-fabricated wiring harness is compatible with System 80 machines that require the ~5 inch board to board harness. This harness includes the highly recommended duplicate ground and power wire installed.

Please be aware the part you receive will vary from the picture. The new CAGS5-A1J4 Wiring Harness now uses modern equivalent housings to replace the obsolete factory housings. There are preinstalled crimps in the modern housing with solder eyelets to install the wires, while heat shrink is used to protect the soldered connection.


  • CAGS5-A1J4
  • A1-J4/A3-J1
0.7 oz

Product Discontinued

Email Me When Available