Shop parts by
NEW! BLUE PINSCORE Display Systems!
Brilliant design makes brilliant displays.
New PINSCORE LED displays for pinball machines are the best performing, most feature-packed and economical replacement systems for obsolete glass plasma digital displays.
This PINSCORE System model PS-8000-PB will work in all of the following Williams pinball machines:
CONTACT
DISCO FEVER
HOT TIP
LUCKY 7 (Solid State)
WORLD CUP
FLASH
PHOENIX
POKERINO
STELLAR WARS
BLACKOUT
FIREPOWER
GORGAR
LASER BALL
SCORPION
TIME WARP
TRI ZONE
Features:
20 minute plug & play installation
Adjustable brightness
Diagnostic pushbutton
Low power consumption-uses only 5 volts and needs no high voltage
Beautiful black matte finish segments and boards
Foam light shields prevent glare from surrounding general illumination
Crisp alpha and numeric digits illuminate in original font
2 year warranty
Built in USA
RoHS compliant
This system contains:
Quantity (1) PS-8000 PINSCORE Master Driver Board
Quantity (4) PS-8019 PINSCORE 6 digit LED Display Board
Quantity (1) PS-LS-6 Foam light shield for 4 or 6 digit Display Board
Quantity (4) PS-LS-7 Foam light shield for 7 digit Display Board
Quantity (2) PS-CABLE2 Ribbon Cable 18"
Quantity (2) PS-CABLE3 Ribbon Cable 24"
Quantity (20) PS-W8-MNT Fibre mounting washers
Reference:
Williams D-8000 Master Display/Driver Board
Williams D-8168 Master Display/discrete Driver board
Williams C-8019 Slave Display Board
UDN7180A
INSTALLATION:
INSTALLATION TIME: About 15 minutes
TOOLS REQUIRED: 1/4” Nutdriver
1. CAUTION: This PS-8000-PB Display System CANNOT be used with any original displays or display driver boards. Damage to both new and old boards will occur if the systems are mixed. Please remove all original boards and cables and install only these new boards and ribbon cables.
2. Unplug the AC power from your pinball machine. Remove game backglass. Unscrew and remove all original glass displays, master driver board and all inter-board connecting cables.
3. Mount all new boards in their respective locations. Use the fibre washers to help clip the board to the standoffs. You may slide the LED display boards horizontally to adjust their positions for alignment with your backglass windows. If not already mounted, place the foam light shields on their respective LED display boards.
4. Connect the new cables. Observe correct polarity on all ribbon cables - the red striped wires on all ribbon cables go to PIN No.1 (also labeled RED) on all boards.
5. Double-check all connections, plug in the machine, and turn the game on. The LED’s will light up. Pressing the DIAGNOSTIC pushbutton on the Master Driver board will illuminate all segments of all displays. This indicates that all boards and cables in the PINSCORE System are operating correctly. Use the thumbwheel BRIGHTNESS control on the Master Driver & Display board to set your preferred illumination level.
![[DNU] PINSCORE Display Sys Wms 3/4/6 Blue [DISCONTINUED]](https://www.datocms-assets.com/137938/1745266494-ps-8000-pb.jpg?w=640&h=640&auto=auto&fit=fill&q=85)
![[DNU] PINSCORE Display Sys Wms 3/4/6 Blue [DISCONTINUED]](https://www.datocms-assets.com/137938/1745266494-ps-8000-pb.jpg?w=640&h=640&auto=auto&fit=fill&q=80)