KISS (Bally) Backglass

#GT-408-37

New Bally KISS pinball machine backglass.

Mirrored, multi layered digital print on 3/16 inch tempered glass with polished corners and edges. Ready for new side and lift trim (available separately under related items below).


BACKGLASS CARE RECOMMENDATIONS:

  • Never apply “Krylon® triple thick” or apply any additional coatings to printed backside of new glass.
  • Alcohol, acetone, and most ‘rattle-can’ liquids must NEVER contact the ink.
  • If laying a glass down on its printed back, always place on a towel or cloth.
  • Glass substrate is tempered and sensitive to significant hot-cold temperature shifts. Make gradual changes to ambient temperatures.
  • Avoid impact or scratches to the edges, such as setting the glass down on concrete.
  • Never allow moisture to remain on the printed backside. After several minutes, there is a risk of ink degradation.
  • Do not spray cleaner directly onto the printed backside. Prolonged contact with liquids may damage your glass.
  • If you must clean the backside (bulb dirt, etc.) wipe with a pre-dampened cloth (water or Windex).
  • After wiping, make sure the liquid is dried off (wipe completely dry). Do not allow moisture to remain on surface.
  • Glass cleaner sprayed directly on the front is OK.
  • Don’t let liquid cleaners seep in between the trim channels and the glass.

    Reference:

  • GT-408-37

13 lb

$289.99

In Stock