Bally CACTUS CANYON Parts
The following parts are known to work in Bally CACTUS CANYON.
-
Glass playfield 21 x 43 x 3/16 inch HD anti-reflection
HD Anti-reflection Glass playfield 21 x 43 x 3/16 inch
In Stock$259.99 -
Lamp socket pop-bumper straight-wire
This is the standard pop bumper socket with solid flat 4" leads used in all Bal...
In Stock$5.49 -
Switch - End Of Stroke - Normally Open
This is a flipper unit END OF STROKE (EOS) switch used on Williams / Bally...
In Stock$7.49 -
Nut 3/8-16 hex 5/8 inch flat to flat
3/8-16 hex machine screw nut, steel & zinc 5/8 across flats
In Stock$0.29 -
Spring - compression
Compression spring used in many different assemblies. Replaces 266-500...
In Stock$0.59 -
Yoke fiber - pop bumper
Fiber yoke fits all pop bumper ring and rod assembles.
In Stock$1.29 -
Flipper opto board Williams/Bally Type 2
New replacement WPC Type 2 Electronic / Opto flipper boards
In Stock$27.99 -
Clip - hairpin retaining
Hairpin retaining clip used to secure shafts and studs on many mechanical assemblies.
In Stock$0.19 -
Thermistor - 8amp 2.5 R25
Thermistor - 8amp 2.5 ohm R25 The thermistor is installed in the power...
In Stock$2.79 -
Coil stop Williams/Bally - later style
Later style coil stop used in Williams/Bally games from 08/1993 to 06-1999...
In Stock$3.99 -
Coil sleeve - 2-1/16 inch with flange
Coil sleeve - 2-1/16 inch with 3/16 inch flange
In Stock$0.99 -
Pivot Bushing - cabinet T-Nut
Williams/ Bally 02-4352 hex socket T-Nut Pivot Bushing with 1/2" shaft, 3/...
In Stock$1.49