Bally CREATURE FROM THE BLACK LAGOON Parts
The following parts are known to work in Bally CREATURE FROM THE BLACK LAGOON.
-
Ball shooter lane feeder assembly Williams
Ball shooter lane feeder assembly Williams
In Stock$29.99 -
Glass Backglass clear 27 x 18-7/8 x 1/8 inches
Clear tempered 27 x 18-7/8 x 1/8 inch thick glass
In Stock$59.99 -
Plumb bob - casting
Common tilt plumb bob with 0.15 inch interior diameter for rod.
In Stock$5.49 -
Lamp cover - USA silicone Red
Made in the USA factory original SILICONE based elastomer lamp covers
In Stock$0.89 -
Washer .390 x .625 x .059 inch shooter
Flat washer used in ball shoooter assemblies .390 x .625 x .059 inch.
In Stock$0.19 -
Pin-Buddy™ Game Saver Cantraption™ 45°
Pin-Buddy™ Game Saver Cantraption&tm 45°
In Stock$19.99 -
E-clip for 3/8 inch shaft - ball shooter rod
Fits shaft diameter of 3/8 inch with groove diameter of 5/16 inch.
In Stock$0.29 -
Latch - toggle back box
Back box toggle latch 20-9347 or tension latch
In Stock$7.49 -
Post stud 8-32 x 2-1/16 inches 6-32 top
Playfield post fastener 6-32 top thread 1/4" long 8-32 bottom thread 3/8 inch
In Stock$2.99 -
Switch cover vinyl - gray small
Replacement grey, flexible vinyl sub-microswitch cover
In Stock$1.99 -
Service switch 4 bank pushbutton
4 pushbutton service switch assembly used Bally / Williams late model coin doors.
In Stock$12.99 -
E-clip for 1/4 in shaft 20A-8712-25
E-clip or e-ring commonly used on many mechanisms. 20A-8712-25 270-5002-00
In Stock$0.29