Williams CONTACT Parts
The following parts are known to work in Williams CONTACT.
-
Pop bumper body Williams 36mm yellow transparent
Pop bumper body Williams 36mm yellow transparent
In Stock$2.99 -
Pop bumper skirt - white
Commonly used pop bumper skirt, or wafer, used in all contemporary machines
In Stock$1.49 -
Potentiometer 5K ohm short shaft
Potentiometer 5K ohm short shaft
In Stock$7.99 -
Rectifier board Williams Sys 3-11A / Data East / Sega
Rectifier board Williams Sys 3-11A / Data East / Sega
In Stock$89.99 -
Resistor kit Williams System 3-7
8 power resistors that replace the original 2 Watt 27 ohm parts
In Stock$9.99 -
Ring and rod
Pop bumper (jet bumper, thumper bumper) ring and rod assembly.
In Stock$6.99 -
Rollover button 3/4 inch - amber transparent
Plastic transparent amber rollover button 3/4 inch used on early Stern and 1970's Williams games
In Stock$3.99 -
Rollover button 3/4 inch yellow trans
Plastic transparent yellow 3/4 inch rollover button used on early Stern and 1970's Williams games
In Stock$2.99 -
Rollover plastic base
Rollover switch plastic base is used with 03-7263 plastic rollover button.
For Reference -
Roll pin 1/8" x 7/16" 20A-8716-5
1/8" diameter x 7/16" length slotted spring roll pin. Reference:...
In Stock$0.39 -
Roll pin 1/8 x 7/16 inches 20A-8716-5
1/8 diameter x 7/16 inches length slotted spring roll pin. USE 20-8716-5
For Reference -
Set screw 1/4-28 x 3/8 inch 2A-3952
Set screw 1/4-28 x 3/8 inch 2A-3952. Replaced by 4008-01083-06.
For Reference