Williams NO FEAR Parts
The following parts are known to work in Williams NO FEAR.
-
Rivet - 1/8 x 5/32 inch long
Zinc-plated steel rivet -1/8 inch shaft diameter x 5/32 inch long
In Stock$0.19 -
Williams Coil bracket
Common knocker coil bracket used in many Williams games.
In Stock$10.99 -
Dot matrix controller board WPC
Dot matrix controller board WPC
For Reference -
Connector - IDC green 11 mt/thru 22/156
11 mt/thru 22/156
In Stock$3.49 -
Switch miniature 1-3/4" bent end lever
Miniature snap action switch with 3 terminals and custom wireform.
Out Of Stock$21.99 -
Connector 2 position .062 inch terminals 045-5107-02
2 position connector uses .062 inch crimp terminals.
In Stock$0.49 -
Resistor SIP 10 pin 4.7k 9r 10 5%
Single inline 10 pin resistor network 4.7k 9r 10 5%
In Stock$2.99 -
Reset plunger finger assy Williams
Williams reset plunger finger assembly.
In Stock$8.99 -
Ball guide - bottom arch fence
Williams/ Bally pinball machine wire ball guide - bottom arch fence used i...
For Reference -
Washer .265 x .500 x .067 inch
Washer 0.265 inch x .500 inch x .067 inch
In Stock$0.19 -
Kicker mounting bracket with 3/16 inch holes
Kicker mounting bracket used on many Williams and Ball/Williams pinball ma...
In Stock$5.99 -
Service outlet snap-in three prong WPC s
Snap-in service outlet used in WPC games. AC inlet IEC PMT 3P. Fits into...
In Stock$2.79