Williams LUCKY SEVEN Parts
The following parts are known to work in Williams LUCKY SEVEN.
-
#5881-09021-00Battery holder 3 position AAStandard Williams / Bally battery holder with through hole circuit board mount terminals.
In Stock$7.99 -
#5040-09051-RCRectifier board Williams Sys 3-11A / Data East / SegaRectifier board Williams Sys 3-11A / Data East / Sega
In Stock$89.99 -
#PC15AC Power Cord - 15 foot stripped endAC Power Cord - 15 foot stripped end
In Stock$12.99 -
#C30KM25VRCapacitor 30,000 uF 25v radial screwCapacitor 30,000 uf @25 volts with screw terminals.
In Stock$26.99 -
#WPRK-1Resistor kit Williams System 3-78 power resistors that replace the original 2 Watt 27 ohm parts
In Stock$9.99 -
#CFREH10Connector .156 inch 10 position rear-entry.156 inch pin spacing 10 Position rear-entry housing
In Stock$4.99 -
#H-WMS37Cable - Williams System 3-7 powerNew wiring harness for Williams System 3 through System 7 pinball machines
In Stock$34.99 -
#PC10AC Power Cord - 10' AC - stripped end10' long 3 wire grounded AC power cord with stripped ends.
In Stock$10.99 -
#CAPKITW34Capacitor Kit - Williams Sys 3 & 4 SoundElectrolytic capacitor replacement set for Williams System 3 and System 4.
In Stock$19.99 -
#1B-2001-124-4Circuit board - drop target switchCircuit board used with horsehoe shaped leaf switch for early Williams solid state.
In Stock$6.49 -
#1B-2001-AK05Drop target contact circuit board kit Williams (4)Drop target contact circuit board kit Williams (4)
In Stock$23.99 -
#1B-2001-AK08Drop target contact circuit board kit Williams (11)Drop target contact circuit board kit Williams (11)
Out Of Stock$55.99