Williams JUNKYARD Parts
The following parts are known to work in Williams JUNKYARD.
-
Machine Screw 6-32 x 3/8" p-ph
Machine screw with 6-32 thread and 3/8 inch long with phillips pan head.
In Stock$0.19 -
Leg - 28-1/2 inch Black- textured
Standard black durable textured finish 28-1/2" ribbed pinball machine leg.
Out Of Stock$33.99 -
Cable clamp 1 inch diameter single
Cable clamp 1 inch diameter single
In Stock$0.59 -
Trough opto trans. board 4-ball Williams
Late model 4-ball transmitter board for Bally/Williams pinball machines. Replaces the A-18617
In Stock$37.99 -
Dome with screw tabs - clear
Clear dome with tabs. Used on many pinball playfields . Replaces 550-5031-01
In Stock$1.99 -
Machine Screw 2-56 x 1/2 inch p-ph-s
This is the small phillips panhead screw used to secure most playfield mic...
In Stock$0.39 -
WPC-95 Power Driver board rebuild kit
WPC-95 Power Driver board rebuild kit
In Stock$34.99 -
Coil - relay no diode
Relay coil without diode
In Stock$22.99 -
Speaker 3 inch - 4 ohm tweeter 15 watts
3 inch tweeter speaker used in backboxes of various pinball machines.
In Stock$34.99 -
Coil
Three terminal coil used in Bally / Williams pinball machines. Refere...
In Stock$22.99 -
Trough opto recvr. board WPC Williams
Newly re-designed opto receiver for late model Williams/Bally WPC-S, WPC-9...
For Reference -
Manual - WPC 95 schematic - July 1
Williams WPC-95 Schematic manual. July 1, 1997. 17" X 11" large format. Original.
In Stock$34.99