Williams JOHNNY MNEMONIC Parts
The following parts are known to work in Williams JOHNNY MNEMONIC.
-
Machine Screw 8-32 x 3/8 inch p-ph-sems
Machine screw 8-32 x 3/8 inch phillips pan head.
In Stock$0.19 -
Trough opto trans. board 4-ball Williams
Late model 4-ball transmitter board for Bally/Williams pinball machines. Replaces the A-18617
In Stock$37.99 -
Actuator arm - brass left
Special brass single drop target trip bracket/actuator.
In Stock$14.99 -
Reflector with lamp socket - silver
This reflector and lamp socket assembly has a silver finish interior.
In Stock$4.99 -
Machine Screw 2-56 x 1/2 inch p-ph-s
This is the small phillips panhead screw used to secure most playfield mic...
In Stock$0.39 -
Speaker 3 inch - 4 ohm tweeter 15 watts
3 inch tweeter speaker used in backboxes of various pinball machines.
In Stock$34.99 -
Machine Screw 10-32 x 5/8" p-ph-s
Machine Screw 10-32 x 5/8" p-ph-s
In Stock$0.29 -
Trough opto recvr. board WPC Williams
Newly re-designed opto receiver for late model Williams/Bally WPC-S, WPC-9...
For Reference -
Bolt 3/8-16 x 1-1/4" round head rib neck
3/8-16 x 1-1/4 inch round head long rib neck carriage bolt
For Reference -
E-clip for 1/8" shaft 270-5000-00
E-clip or e-ring commonly used on many mechanisms. 1/8" measured at the op...
In Stock$0.19 -
Machine Screw 6-32 x 1/2 inch p-ph-sems
Machine screw with 6-32 thread and 1/2 inch long with phillips pan head
In Stock$0.39 -
Coil - solenoid
Common solenoid coil used on many manufacturers pinball machines.
In Stock$19.99