Bally GILLIGANS ISLAND Parts
The following parts are known to work in Bally GILLIGANS ISLAND.
-
Cable clamp 1 inch diameter single
Cable clamp 1 inch diameter single
In Stock$0.59 -
Motor - Williams
Williams motor assembly
In Stock$79.99 -
Spring - extension
Extension spring. Reference: 10-362
In Stock$0.59 -
Machine Screw 2-56 x 1/2 inch p-ph-s
This is the small phillips panhead screw used to secure most playfield mic...
In Stock$0.39 -
Machine Screw 10-32 x 5/8" p-ph-s
Machine Screw 10-32 x 5/8" p-ph-s
In Stock$0.29 -
Pivot Nut 1/2 inch
Pivot nut 1/2 inch. Reference: 02-4329
In Stock$3.49 -
Coil stop - Williams/Bally
Williams/Bally coil stop assembly with 3/8" centerline mounting holes.
In Stock$7.49 -
PAL nut 5/8 inch
This 'PAL' nut. Replaced by 20-9222
For Reference -
Relay - 12 VDC assembly
Williams System 11 pinball machine 12 volt solenoid and General Illumiatio...
For Reference -
Nut 6-32 wing - plumb bob wire
Wing nut with 6-32 thread for plumb bob tilt assembly wire.
In Stock$0.19 -
E-clip for 1/8" shaft 270-5000-00
E-clip or e-ring commonly used on many mechanisms. 1/8" measured at the op...
In Stock$0.19 -
Post spacer #8 x 1 inch
Post spacer #8 x 1 inch
In Stock$5.49