Williams DINER Parts
The following parts are known to work in Williams DINER.
-
Plumb bob - casting
Common tilt plumb bob with 0.15 inch interior diameter for rod.
In Stock$5.49 -
Twin nut plate - Tinnerman switch stack
Twin nut 2 hole spring steel switch stack retainer
In Stock$0.99 -
E-clip for 3/16" shaft 20A-8712-18
E-clip or e-ring commonly used on many 3/16" mechanism shafts
In Stock$0.29 -
E-clip for 1/4 in shaft 20A-8712-25
E-clip or e-ring commonly used on many mechanisms. 20A-8712-25 270-5002-00
In Stock$0.19 -
Roll pin 1/8" x 7/16" 20A-8716-5
1/8" diameter x 7/16" length slotted spring roll pin. Reference:...
In Stock$0.39 -
Nyliner® 1/4 inch bearing
Standard snap-in Nyliner® bearing bushing with 1/4 inch Inner Diameter
In Stock$0.99 -
Ball shooter rod - black
Universal Ball Shooter rod with black plastic knob. Used on all Williams /...
In Stock$9.99 -
Roll pin 5/32 x 7/16 inch
Split roll pin 5/32 x 7/16 inch. Reference: 251-5000-00
In Stock$0.59 -
nut hex M3 x .5
nut hex M3 x .5
In Stock$0.19 -
Switch cover vinyl - orange large
Replacement 1-1/4" wide X 1" tall X 1/2" deep orange vinyl switch protect...
In Stock$1.99 -
Rubber grommet
Rubber grommet. Replaced by 38-6420
For Reference -
Tape - double sided 1 inch wide / per foot
Tape - double sided 1 inch wide / per foot
In Stock$5.99