Williams FLASH Parts
The following parts are known to work in Williams FLASH.
-
Pin-Buddy™ Game Saver Cantraption™ 45°
Pin-Buddy™ Game Saver Cantraption&tm 45°
In Stock$19.99 -
Plunger & link Williams 1969-79
Plunger and link assembly for late electromechanical and early solid state Williams flippers.
In Stock$7.99 -
Nyliner® 1/4 inch bearing
Standard snap-in Nyliner® bearing bushing with 1/4 inch Inner Diameter
In Stock$0.99 -
Capacitor 30,000 uF 25v radial screw
Capacitor 30,000 uf @25 volts with screw terminals.
In Stock$26.99 -
Resistor kit Williams System 3-7
8 power resistors that replace the original 2 Watt 27 ohm parts
In Stock$9.99 -
Leaf switch assembly pop bumper dual right tie SW-11A-35-1
Leaf switch assembly pop bumper dual right tie SW-11A-35-1
In Stock$18.99 -
Spring - compression jet bumper
Compression spring used on pop bumper assemblies and others.
In Stock$0.59 -
Glass corner protectors - Set of 2
Glass corner protectors - Set of 2
In Stock$9.99 -
Coil - flipper SFL-20-300/30-800
Coil - flipper SFL-20-300/30-800
In Stock$21.99 -
Flipper bushing - Williams 3A-6014
Williams Flipper Bushing for electromechanical and early solid state flipp...
In Stock$2.79 -
Plunger - pop bumper
Williams/Bally pop bumper plunger. Reference: 02-3406-1 2A-340...
In Stock$4.99 -
Connector .156 inch 10 position rear-entry
.156 inch pin spacing 10 Position rear-entry housing
In Stock$4.99