Williams MEDIEVAL MADNESS (Williams) Parts
The following parts are known to work in Williams MEDIEVAL MADNESS (Williams).
-
Cable clamp 1 inch diameter single
Cable clamp 1 inch diameter single
In Stock$0.59 -
Trough opto trans. board 4-ball Williams
Late model 4-ball transmitter board for Bally/Williams pinball machines. Replaces the A-18617
In Stock$37.99 -
Machine Screw 2-56 x 1/2 inch p-ph-s
This is the small phillips panhead screw used to secure most playfield mic...
In Stock$0.39 -
WPC-95 Power Driver board rebuild kit
WPC-95 Power Driver board rebuild kit
In Stock$34.99 -
Speaker 3 inch - 4 ohm tweeter 15 watts
3 inch tweeter speaker used in backboxes of various pinball machines.
In Stock$34.99 -
Post - 1-1/4 inch narrow red
Post - 1-1/4 inch narrow red
In Stock$1.09 -
Coil
Three terminal coil used in Bally / Williams pinball machines. Refere...
In Stock$22.99 -
Trough opto recvr. board WPC Williams
Newly re-designed opto receiver for late model Williams/Bally WPC-S, WPC-9...
For Reference -
Manual - WPC 95 schematic - July 1
Williams WPC-95 Schematic manual. July 1, 1997. 17" X 11" large format. Original.
In Stock$34.99 -
Bolt 3/8-16 x 1-1/4" round head rib neck
3/8-16 x 1-1/4 inch round head long rib neck carriage bolt
For Reference -
E-clip for 1/8" shaft 270-5000-00
E-clip or e-ring commonly used on many mechanisms. 1/8" measured at the op...
In Stock$0.19 -
Switch sub-mini assembly
Sub miniature snap action switch with 3 terminals and custom wireform
Out Of Stock$15.99