Williams INDIANA JONES (Williams) Parts
The following parts are known to work in Williams INDIANA JONES (Williams).
-
Fish paper display shield dot matrix Williams
Dot Matrix Display fish paper rear shield for WPC-95 games.
In Stock$9.99 -
Service outlet snap-in three prong WPC s
Snap-in service outlet used in WPC games. AC inlet IEC PMT 3P. Fits into...
In Stock$2.79 -
Logic power cable WPC
Logic power cable for Williams WPC pinball machines. Reference: H-15...
For Reference -
Spring - compression
Compression spring.
In Stock$0.99 -
E-clip for 7/16 in. shaft
E-clip or e-ring commonly used on many mechanisms. 7/16 in. measured at the o...
In Stock$0.29 -
Pushbutton 1 inch round white 'Start'
Pushbutton 1 inch round white 'Start'
In Stock$10.99 -
Foam rubber protector 3/4" wide x 22-1/8" long x 1/4" thick
22-1/8 inch long foam rubber protector for widebody pinball machine front trim moldings.
In Stock$5.99 -
Connector - IDC orange 13 position
13 position Insulation Displacement Connector (IDC).
In Stock$7.49 -
IC 16 pin DIP DAC AD1851 16 bit mono
Integrated circuit 16 pin DIP AD-1851 16 bit mono audio PCM.
For Reference -
Plate - spacer cabinet slide
Plate - spacer pinball machine cabinet slide. Reference: 01-11408
In Stock$9.99 -
Connector 2 position .093" terminals
2 position plug with no mounting ears uses .093" crimp terminals.
In Stock$1.49 -
T-Nut 8-32 1/4" barrel - 19/32" base
1/4" tall barrel and 8-32 thread with 19/32"" base or flange.
In Stock$0.29