Bally POPEYE Parts
The following parts are known to work in Bally POPEYE.
-
Rivet - 1/8 x 1/4 inches nickel
Rivet - 1/8 x 1/4 inches nickel
In Stock$0.19 -
Connector 2 position .062 inch terminals 045-5107-02
2 position connector uses .062 inch crimp terminals.
In Stock$0.49 -
Resistor SIP 10 pin 4.7k 9r 10 5%
Single inline 10 pin resistor network 4.7k 9r 10 5%
In Stock$2.99 -
Washer .265 x .500 x .067 inch
Washer 0.265 inch x .500 inch x .067 inch
In Stock$0.19 -
E-clip for 3/8 inch shaft - ball shooter rod
Fits shaft diameter of 3/8 inch with grove diameter of 5/16 inch.
For Reference -
Dome with screw tabs - blue
Used on many manufactures pinball playfields for flash lamp covers Use...
In Stock$1.79 -
WPC Schematic Manual May 1993
WPC Schematic Manual revised May 17th, 1993. Original
Out Of Stock$19.99 -
Kicker mounting bracket with 3/16 inch holes
Kicker mounting bracket used on many Williams and Ball/Williams pinball ma...
In Stock$5.99 -
Fish paper display shield dot matrix Williams
Dot Matrix Display fish paper rear shield for WPC-95 games.
In Stock$9.99 -
Service outlet snap-in three prong WPC s
Snap-in service outlet used in WPC games. AC inlet IEC PMT 3P. Fits into...
In Stock$2.79 -
Post #8 x 1-3/16 inch star blue transparent
Post #8 x 1-3/16 inch star blue transparent
In Stock$0.99 -
E-clip for 7/16 in. shaft
E-clip or e-ring commonly used on many mechanisms. 7/16 in. measured at the o...
In Stock$0.49