Shop parts by
Rectifier board heat sink spacer Stern TA-100
CALIFORNIA WARNING
This product can expose you to chemicals, including lead and DEHP, which are known to the State of California to cause cancer and birth defects, or other reproductive harm. For more information, go to https://www.p65warnings.ca.gov.
Rectifier / fuse board TA-100 heat sink spacer for early Bally and Stern Electronics, Inc.1 pinball machines.
Aluminum spacer is 3.25 x 3/4 x 5/32 inches thick.
Reference:
A-430-H rectifier module
A-430 rectifier module
AS-2518-18
P-1973-399
1NOTE:
Stern Electronics, Inc. made pinball machines between 1977 and 1984 and their products are commonly referred to as Classic Stern or Early Stern SEI pinball machines.
Stern Pinball, Inc. was established in 1999 and currently manufactures pinball machines referred to as New Stern pinball machines.
Most parts used by these different generations of pinball machines are not interchangeable with each other.
Select manufacturer to view game compatibility
Bracket - coil support Stern/CCM
Coil stop bracket for Chicago Coin and early SEI Stern flippers.
Rectifier board bracket Stern TA-100
200 volt 10 amp bridge rectifier replacement for Bally AS-2518-18 rectifier board
One piece molded red 3 inch flipper & shaft assembly used on...
Drop target assembly Stern SEI
Power Transformer A2 Module - Bally
One piece molded white flipper & shaft assembly used on Bally & others.
Pop bumper or thumper bumper assembly for early Chicago Coin and Stern pinball.
Flipper stop bracket Stern/CCM
