Chicago Gaming Company Monster Bash Remake Classic Edition Parts
The following parts are known to work in Chicago Gaming Company Monster Bash Remake Classic Edition.
- Prev
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 11
- 12
- 13
- 14
- 15
- 16
- 17
- 18
- 19
- 20
- 21
- 22
- 23
- 24
- 25
- 26
- 27
- 28
- 29
- 30
- 31
- 32
- 33
- 34
- 35
- 36
- 37
- 38
- 39
- Next
-
#4408-01118-01T-Nut 8-32 thread 1/4 inch barrel 1/2 inch baseSteel and zinc 3-prong tee nut. 8-32 tee, 1/2 inch base.
In Stock$0.19 -
#20-8712-12E-clip for 1/8" shaft 270-5000-00E-clip or e-ring commonly used on many mechanisms. 1/8" measured at the op...
In Stock$0.20 -
#4408-01119-01Nut 8-32 ESNA/NTM stop nutStop nut 8-32 thread.
In Stock$0.15 -
#4406-01117-00Nut 6-32 hex6-32 nut used on Williams flipper plates to secure flipper bushings.
In Stock$0.09 -
#AE-25-1000Coil - solenoidSolenoid coil
In Stock$14.95 -
#03-8044-13Minipost - plastic clear 1 inch tallMinipost - plastic clear 1 inch tall
In Stock$0.60 -
#02-5107Adjusting postDual rubber ring adjustable post used on many late model machines.
In Stock$1.99 -
#041-5029-04Motor - shaker (041-5029-01) RoHSShaker motor without connector assembly.
In Stock$49.95 -
#5490-14575-00Opto sensor - flipper - 5 legOpto transmitter & receiver packaged in U-shaped black plastic housing.
In Stock$5.95 -
#20-10289Plumb bob fastener-Tinnerman clip - zincTinnerman clip used to secured the plumb bob tilt on late model tilt assemblies.
In Stock$0.89 -
#01-1747Bracket - Coil RetainerCoil retainer bracket
In Stock$1.99 -
#AE-30-2000Coil - solenoidCommon solenoid coil used on many manufacturers pinballs
Out Of Stock$10.95