Gottlieb BIG HURT Parts
The following parts are known to work in Gottlieb BIG HURT.
-
#DMD32Dot matrix display for pinball machinesDot matrix display (DMD) for pinball machines
In Stock$499.99 -
#77-ACPPlug - AC 110 volt powerHeavy duty 3 prong grounded 15 amp 110v AC power cord replacement plug
In Stock$6.49 -
#C2.2M250VA-NPCapacitor 2.2 uF 250v axial NP yellowYellow wrapper 2.2 uF @ 250 volt axial lead non-polarized metalized polyester. 125-5002-00
In Stock$2.49 -
#PC15AC Power Cord - 15 foot stripped endAC Power Cord - 15 foot stripped end
In Stock$13.99 -
#STP22NE10LTransistor - N Mosfet 100v 22a TO-220 110-0106-00 USE IRL540MOSFET transistor driver N channel 100V - 0.07 ohm - 22A
For Reference -
#IRL540Transistor N channel 100v 20a Mosfet 110-0088-00 TO-220Transistor N channel 100v 20a Mosfet TO-220 110-0088-00
In Stock$3.99 -
#MA-1334Opto board Gottlieb® flipper sensor A15Gottlieb flipper sensor board A15
In Stock$29.95 -
#GTB-SEMI-DMC3Dot Matrix Control rebuild kit GTB Sys 320 piece rebuild kit of electronic components for a "shotgun" repair of Go...
In Stock$11.95 -
#MA-1851Control switch board Gottlieb® A26A-26 Game Control Board for Gottlieb System 3 pinball machines.
In Stock$30.00 -
#PC10AC Power Cord - 10' AC - stripped end10' long 3 wire grounded AC power cord with stripped ends.
In Stock$12.99 -
#MA-1739Display controller board Gottlieb® A8Display controller board Gottlieb® A8 for System 3 pinball machines.
Out Of Stock$299.99 -
#XO-1079IC - 20 pin DIP programmed Gottlieb GAL16V8BIC - 20 pin DIP programmed Gottlieb GAL16V8B
In Stock$39.00