Williams JOHNNY MNEMONIC Parts
The following parts are known to work in Williams JOHNNY MNEMONIC.
-
#03-16809Trough anti-mag shim Williams/Bally upgradeTrough anti magnetic shim - Williams/Bally upgrade
In Stock$7.99 -
#SW-1A-194Switch - End Of Stroke - Normally OpenThis is a flipper unit END OF STROKE (EOS) switch used on Williams / Bally...
In Stock$4.99 -
#4422-01117-00Nut 3/8-16 hex 5/8 inch flat to flat3/8-16 hex machine screw nut, steel & zinc 5/8 across flats
In Stock$0.29 -
#03-8229-30Lift trim plastic - backglass 30 inchStandard backglass lift trim with 3/16 inch channel. Trim as needed. Used in...
For Reference -
#5410-12426-01IC - ASIC Williams WPC CPU chipApplication Specific Integrated Circuit (ASIC) chip for Williams/Bally WPC
In Stock$104.99 -
#A-20207-PFlipper opto board Williams/Bally Type 2New replacement WPC Type 2 Electronic / Opto flipper boards
In Stock$21.99 -
#10-128Spring - compressionCompression spring used in many different assemblies. Replaces 266-500...
In Stock$0.59 -
#01-5493Yoke fiber - pop bumperFiber yoke fits all pop bumper ring and rod assembles.
In Stock$1.29 -
#12-6227Clip - hairpin retainingHairpin retaining clip used to secure shafts and studs on many mechanical assemblies.
In Stock$0.49 -
#5016-12978-00Thermistor - 8amp 2.5 R25Thermistor - 8amp 2.5 ohm R25 The thermistor is installed in the power...
In Stock$3.99 -
#01-6389-1Cashbox nest bracketCashbox nest bracket Williams
In Stock$8.99 -
#03-7067-5Coil sleeve - 2-1/16 inch with flangeCoil sleeve - 2-1/16 inch with 3/16 inch flange
In Stock$0.89