Williams HOT TIP - Solid State Parts
The following parts are known to work in Williams HOT TIP - Solid State.
-
Yoke fiber - pop bumper
Fiber yoke fits all pop bumper ring and rod assembles.
In Stock$1.29 -
Clip - hairpin retaining
Hairpin retaining clip used to secure shafts and studs on many mechanical assemblies.
In Stock$0.49 -
Coil - solenoid with diode (SA=SG)
Coil - solenoid with diode (SA = SG)
In Stock$16.99 -
Glass playfield 21 x 43 x 3/16 inch HD anti-reflection
Glass playfield 21 x 43 x 3/16 inch HD anti-reflection
Out Of Stock$259.99 -
Spring - barrel compression shooter brass
Spring - barrel compression shooter brass
In Stock$0.89 -
Lift trim 3/16 x 28.5 inch Bally stainless
Bottom polished stainless steel retainer lift trim for 3/16" thick backglass.
In Stock$24.99 -
Plunger & link Williams 1969-79
Plunger and link assembly for late electromechanical and early solid state Williams flippers.
In Stock$7.99 -
Pin-Buddy™ combo kit
Pin-Buddy™ combo kit
In Stock$44.99 -
AC Power Cord - 15 foot stripped end
AC Power Cord - 15 foot stripped end
In Stock$13.99 -
Capacitor 30,000 uF 25v radial screw
Capacitor 30,000 uf @25 volts with screw terminals.
Out Of Stock$16.99 -
Resistor kit Williams System 3-7
8 power resistors that replace the original 2 Watt 27 ohm parts
In Stock$9.95 -
Leaf switch assembly pop bumper dual right tie SW-11A-35-1
Leaf switch assembly pop bumper dual right tie SW-11A-35-1
In Stock$18.99