Machine screw 8-32 thread x 1/2" long phillips round head with sems extern...
DEMOLITION MAN (Williams) Cryoclaw opto board
Williams Protective Cap. Used on: ATTACK FROM MARS BUGS BUNNY BLACK...
Label for lockbar receiver mechanism on Williams WPC pinball machines with...
Pin-Buddy™ Game Saver Cantraption™ 45° LIGHT BLUE
Lock Washer 1/4-20 internal tooth black
DEMOLITION MAN (Williams) Ribbon cable kit
DEMOLITION MAN (Williams) Trigger Kit
Bolt 1/4-20 x 1" hex head.
stand up sw assy
Williams DEMOLITION MAN 6 Lamp under playfield circuit board includes all...
Sub miniature snap action switch with 3 terminals and custom actuator lever
Williams Demolition Man Wire Ramp.
Sheet Metal Screw #8 x 5/8 inch pl-hwh-a
Target switch - 3D square red
1/8 diameter x 7/16 inches length slotted spring roll pin. USE 20-8716-5
Set screw 8-32 x 3/8" SP-CP
Leg bolt 3/8-16 thread with 5/8 inch acorn head and 2-1/4 inch length.
Resistor 4.7 kohm 5 watt 5%Reference: 5012-12843-00
Connector IDC 8r mt/end 22/.100
Crystal 10.0 MHz Reference: 5520-13301-00
Eject cam mounting bracket assembly. Reference: A-18146
Washer - modified crank washer
Machine Screw 10-32 x 7/8 inch p-ph-s
Roll pin 1/16 x 5/16 inch
5 position plug uses .062 inch crimp terminals.
Sheet Metal Screw #6 x 3/8 inch p-rh-a
Pop bumper cap - orange trans starburst
Flat washer 0.70" x 1.19" x 0.09" thick.
5 position receptacle with mounting ears uses .062 inch crimp terminals.
DEMOLITION MAN (Williams) Speaker panel
Resistor 1.8k ohm 5 watt 5%
Switch gate bracket Williams
Plate-Nut
cashbox sub assy parts
Sheet Metal Screw #4 x 1/2 nch p-ph
Integrated circuit 74HC161
Williams DEMOLITION MAN speaker cutout promotional coaster with Sylvester...
DEMOLITION MAN (Williams) ball popper trough
Rivet brass - 1/8 inch shaft diameter x 5/32 inch shaft length
Williams DEMOLITION MAN Cryoclaw Support arm
Williams DEMOLITION MAN pinball machine right ramp guard #3. Reference:...
Flange bearing
Diverter bracket Bally/Williams
Leaf switch - kicker
Bayonet lamp holder for #89 and similar base bulbs. Replaced by 077-5101-00
Williams 25 Lamp PCB. Used in games such as Bally POPEYE SAVES THE EARTH...
Steel and zinc #8 X 11/16 unslotted hex-washer head hi-fast screw.
IC - 3 pin TO-92 -5v regulator LM79L05
Machine screw with 6-32 thread and 3/4 inch long with phillips pan head.
IC - 20 pin DIP 74ALS576 octal D-type f-f
DEMOLITION MAN (Williams) Backbox bracket set
cryo-Bracket assy
DEMOLITION MAN (Williams) Post Kit
Williams Demolition Man Cryo Claw Base.
Pop bumper body Williams 36mm red transparent
Heat sink TO-220
IC - 14 pin DIP quad 2-input positive-NAND gate 74F00
Torx® wrench key T-25 tamper resistant
Wire ball guide rail 2"
