Bally SHADOW Parts
The following parts are known to work in Bally SHADOW.
- Prev
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 11
- 12
- 13
- 14
- 15
- 16
- 17
- 18
- 19
- 20
- 21
- 22
- 23
- 24
- 25
- 26
- 27
- 28
- 29
- 30
- 31
- 32
- 33
- 34
- 35
- 36
- 37
- 38
- 39
- 40
- 41
- 42
- 43
- 44
- 45
- 46
- 47
- 48
- 49
- 50
- 51
- 52
- 53
- 54
- 55
- 56
- Next
-
#03-8229-30Lift trim plastic - backglass 30 inchStandard backglass lift trim with 3/16 inch channel. Trim as needed. Used in...
Out Of Stock -
#23-6534-9Foam rubber protector 3/4 x 3/8 x 1/4 inchGray foam protector pre-cut pads commonly used in target switches
In Stock$0.29 -
#01-6389-1Cashbox nest bracketCashbox retainer nest bracket for Williams / Bally late model machines.
In Stock$7.25 -
#A-5103Plunger & link - slingshot assembly 2 inchPlunger and link assembly for many Williams/Bally and other manufacturer p...
In Stock$3.99 -
#20-9718Wing bolt - 2 inch back boxWING SCREW or WING BOLT used on late model WPC system games.
In Stock$3.89 -
#SW-1A-194Switch - End Of Stroke - Normally OpenThis is a flipper unit END OF STROKE (EOS) switch used on Williams / Bally...
In Stock$3.99 -
#A-20207-PFlipper opto board Williams/Bally Type 2New replacement WPC Type 2 Electronic / Opto flipper boards
In Stock$17.99 -
#FL-15411Coil - flipper orange - medium strong3 terminal, dual winding flipper coil is used on the following machines:...
In Stock$19.95 -
#10-149-KSpring - barrel compression shooter blackSpring - barrel compression shooter black
In Stock$0.69 -
#4422-01117-00Nut 3/8-16 hex 5/8 inch flat to flat3/8-16 hex machine screw nut, steel & zinc 5/8 across flats
In Stock$0.18 -
#5410-12426-01IC - ASIC Williams WPC CPU chipApplication Specific Integrated Circuit (ASIC) chip for Williams/Bally WPC
In Stock$104.99 -
#5016-12978-00Thermistor - 8amp 2.5 R25Thermistor - 8amp 2.5 ohm R25 The thermistor is installed in the power...
In Stock$3.99