Williams FIREPOWER Parts
The following parts are known to work in Williams FIREPOWER.
-
#P-6242-71Lift trim 3/16 x 28.5 inch Bally stainlessBottom polished stainless steel retainer lift trim for 3/16" thick backglass.
In Stock$24.99 -
#SFL-19-400_30-7Coil - flipper SFL-19-400/30-750Flipper coil
In Stock$25.99 -
#20-8712-37E-clip for 3/8 inch shaft - ball shooter rodFits shaft diameter of 3/8 inch with groove diameter of 5/16 inch.
In Stock$0.49 -
#20-8712-25E-clip for 1/4 in shaft 20A-8712-25E-clip or e-ring commonly used on many mechanisms. 20A-8712-25 270-5002-00
In Stock$0.39 -
#77-PBY-KITPin-Buddy™ combo kitPin-Buddy™ combo kit
In Stock$44.99 -
#PC15AC Power Cord - 15 foot stripped endAC Power Cord - 15 foot stripped end
In Stock$13.99 -
#C30KM25VRCapacitor 30,000 uF 25v radial screwCapacitor 30,000 uf @25 volts with screw terminals.
Out Of Stock$16.99 -
#WPRK-1Resistor kit Williams System 3-78 power resistors that replace the original 2 Watt 27 ohm parts
In Stock$9.95 -
#SW-11A-35Leaf switch assembly pop bumper dual right tie SW-11A-35-1Leaf switch assembly pop bumper dual right tie SW-11A-35-1
In Stock$18.99 -
#10-326Spring - compression jet bumperCompression spring used on pop bumper assemblies and others.
In Stock$0.59 -
#02-3406-1Plunger - pop bumperWilliams/Bally pop bumper plunger. Reference: 02-3406-1 2A-340...
In Stock$4.99 -
#CFREH10Connector .156 inch 10 position rear-entry.156 inch pin spacing 10 Position rear-entry housing
In Stock$4.99