Williams GORGAR Parts
The following parts are known to work in Williams GORGAR.
-
#A-6939-1Plunger & link Williams 1969-79Plunger and link assembly for late electromechanical and early solid state Williams flippers.
In Stock$7.99 -
#77-PBY-KITPin-Buddy™ combo kitPin-Buddy™ combo kit
In Stock$44.99 -
#PC15AC Power Cord - 15 foot stripped endAC Power Cord - 15 foot stripped end
In Stock$13.99 -
#C30KM25VRCapacitor 30,000 uF 25v radial screwCapacitor 30,000 uf @25 volts with screw terminals.
Out Of Stock$16.99 -
#WPRK-1Resistor kit Williams System 3-78 power resistors that replace the original 2 Watt 27 ohm parts
In Stock$9.95 -
#SW-11A-35Leaf switch assembly pop bumper dual right tie SW-11A-35-1Leaf switch assembly pop bumper dual right tie SW-11A-35-1
In Stock$18.99 -
#10-326Spring - compression jet bumperCompression spring used on pop bumper assemblies and others.
In Stock$0.59 -
#SFL-20-300_30-8Coil - flipper SFL-20-300/30-800Coil - flipper SFL-20-300/30-800
In Stock$18.99 -
#02-3406-1Plunger - pop bumperWilliams/Bally pop bumper plunger. Reference: 02-3406-1 2A-340...
In Stock$4.99 -
#03-6014Flipper bushing - Williams 3A-6014Williams Flipper Bushing for electromechanical and early solid state flipp...
In Stock$2.79 -
#CFREH10Connector .156 inch 10 position rear-entry.156 inch pin spacing 10 Position rear-entry housing
In Stock$4.99 -
#03-7034-9Lane guide - 2-1/8 inch red A-9394Lane guide - 2-1/8 inch red A-9394
In Stock$2.79