Bally SAFE CRACKER Parts
The following parts are known to work in Bally SAFE CRACKER.
-
E-clip for 7/16 in. shaft
E-clip or e-ring commonly used on many mechanisms. 7/16 in. measured at the o...
For Reference -
Resistor 4.7k ohm 5w radial
Resistor 4.7k ohm 5w radial
In Stock$0.49 -
E-clip for 7/16 in. shaft
E-clip or e-ring commonly used on many mechanisms. 7/16 in. Replaced by 20-8712-43
For Reference -
SAFECRACKER (Bally) overlay
Bally SAFE CRACKER translite
In Stock$139.99 -
Machine Screw 8-32 x 5/8" p-flh
Machine screw 8-32 thread x 5/8" long phillips flat head.
In Stock$0.19 -
Connector 12 position .062 inch terminals
12 position receptacle with no mounting ears uses .062 inch crimp terminals.
In Stock$0.99 -
Pop bumper body Williams 36mm red transparent
Pop bumper body Williams 36mm red transparent
In Stock$2.99 -
Flipper crank bolt with flat 90 degree notch washer modified
Flipper crank bolt with flat 90 degree notch washer modified for use on flipper pawl.
For Reference -
Connector IDC 7r mt/end 22/.100
Connector IDC 7r mt/end 22/.100
In Stock$0.99 -
Nut 3/8-16 hex 9/16 flat to flat 7/32 inch thick
Nut 3/8-16 hex 9/16 flat to flat 7/32 inch thick
In Stock$0.39 -
Dot Matrix 128 x 32 LED display
New 128 x 32 LED Dot Matrix Display module for pinball machines
In Stock$329.99 -
Foam rubber protector 3/4" wide x 3-5/8" long x 1/4" thick
Foam rubber protector 3-5/8 inches long - black
In Stock$0.99