Bally MATA HARI - Solid State Parts
The following parts are known to work in Bally MATA HARI - Solid State.
-
#6800IC - 40 pin DIP MC6800P Microprocessor IC6800 Microprocessor 40 pin Integrated Circuit used in most early solid state pinball.
In Stock$9.99 -
#6810IC - 24 pin DIP 128 x 8 Ram, R/W memory24 pin DIP Integrated circuit 128 x 8 RAM read/write.
In Stock$5.99 -
#PC15AC Power Cord - 15 foot stripped endAC Power Cord - 15 foot stripped end
In Stock$13.99 -
#CF10028Connector .100 inch 28 position female.100 inch 28 Position female molex housing.
In Stock$5.99 -
#1N4148Diode - 100 volt 0.15a XO-261Diode small signal switching 100V 0.3A 2-Pin DO-35
In Stock$0.35 -
#ULTCOMBOULTIMATE MPU Board & TEST Card COMBOSAVE $10.00 when you order both the ULTIMATE MPU and ULTIMATE TEST...
In Stock$234.95 -
#M-1837HV shield solenoid driver BallyClear plastic plexiglass High Voltage safety shield for Bally solenoid driver board
In Stock$5.99 -
#PC10AC Power Cord - 10' AC - stripped end10' long 3 wire grounded AC power cord with stripped ends.
In Stock$12.99 -
#5043-09030-00Capacitor .047M 50V +/-20 axialcap .047M 50V +/-20 axial
In Stock$0.29 -
#E-00599-0015Potentiometer 10 Kohm linear PCB mountPotentiometer 10 Kohm linear PCB mount
In Stock$3.49 -
#PS2518-18-STRectifier board Bally/Stern AS-2518-18/49 TA-100 C-464 soldeRectifier board Bally/Stern AS-2518-18/49 TA-100 C-464
In Stock$104.99 -
#R10W600Resistor - 600 ohm 10 watt10 watt 600 power resistor in cement package. Used as R1 on Bally rectifier board
In Stock$2.69