Williams INDIANA JONES (Williams) Parts
The following parts are known to work in Williams INDIANA JONES (Williams).
-
.100 inch 12 Positon Male Header
.100 inch 12 Position male molex header. Reference: Williams 5791-12461...
In Stock$1.29 -
Torx® wrench key T-25 tamper resistant
Torx® wrench key T-25 tamper resistant
In Stock$5.99 -
Resistor 120 ohm 5w 5% USE R5W120
Resistor 120 ohm 5w 5%. Replaced by R5W120
For Reference -
INDIANA JONES (Williams) Plastic assy.
INDIANA JONES (Williams) plastic assy. Reference: A-16912-3
For Reference -
E-clip for 7/16 in. shaft
E-clip or e-ring commonly used on many mechanisms. 7/16 in. measured at the o...
For Reference -
INDIANA JONES (Williams) 2 led flasher board
INDIANA JONES (Williams) 2 led flasher board
In Stock$49.99 -
E-clip for 7/16 in. shaft
E-clip or e-ring commonly used on many mechanisms. 7/16 in. Replaced by 20-8712-43
For Reference -
Pop bumper body Williams 36mm red transparent
Pop bumper body Williams 36mm red transparent
In Stock$2.99 -
Dot Matrix 128 x 32 LED display
New 128 x 32 LED Dot Matrix Display module for pinball machines
Out Of Stock$329.99 -
Flipper crank bolt with flat 90 degree notch washer modified
Flipper crank bolt with flat 90 degree notch washer modified for use on flipper pawl.
For Reference -
Connector IDC 7r mt/end 22/.100
Connector IDC 7r mt/end 22/.100
In Stock$0.99 -
Foam rubber protector 3/4" wide x 3-5/8" long x 1/4" thick
Foam rubber protector 3-5/8 inches long - black
In Stock$0.99