Williams INDIANA JONES (Williams) Parts
The following parts are known to work in Williams INDIANA JONES (Williams).
-
Pop bumper cap - red transparent
Red transparent pop bumper cap
In Stock$2.99 -
IC - ASIC Williams WPC CPU chip
Application Specific Integrated Circuit (ASIC) chip for Williams/Bally WPC
In Stock$104.99 -
Lamp socket pop-bumper straight-wire
This is the standard pop bumper socket with solid flat 4" leads used in all Bal...
In Stock$5.49 -
Switch - End Of Stroke - Normally Open
This is a flipper unit END OF STROKE (EOS) switch used on Williams / Bally...
In Stock$7.49 -
Nut 3/8-16 hex 5/8 inch flat to flat
3/8-16 hex machine screw nut, steel & zinc 5/8 across flats
In Stock$0.29 -
Spring - compression
Compression spring used in many different assemblies. Replaces 266-500...
In Stock$0.59 -
Yoke fiber - pop bumper
Fiber yoke fits all pop bumper ring and rod assembles.
In Stock$1.29 -
Coil - flipper orange - medium strong
3 terminal, dual winding flipper coil is used on the following machines:...
In Stock$23.99 -
Flipper opto board Williams/Bally Type 2
New replacement WPC Type 2 Electronic / Opto flipper boards
In Stock$27.99 -
Reset Fix Board WPC Power Driver
Reset Fix Board WPC Power Driver
In Stock$59.99 -
Lift trim plastic - backglass 30 inch
Standard backglass lift trim with 3/16 inch channel. Trim as needed. Used in...
For Reference -
Thermistor - 8amp 2.5 R25
Thermistor - 8amp 2.5 ohm R25 The thermistor is installed in the power...
In Stock$2.79